FS: Renishaw PHC10-2 Controller
The PHC10-2 controls all head functions and reports system status to the CMM:
* Drives PH10 (PH10T, PH10M or PH10MQ) to position - sent either from the HCU1 or CMM.
* Checks and reports position
* Flags up errors, e.g. failure to reach position, obstruction before or after locking etc.
The PHC10-2 does not process any of the probe sensor signals. These are railed clean through the heads axes and controller to the probe interface.
This is left over equipment from a recent business closure. It functions properly and has no damage internally or externally.
**Comes with rack mounting brackets**
These go for $2000+ new. This is a steal!!
$1000
|